There are several command-line tools for managing a wireless network interface in Linux systems. A number of these can be used to simply view the wireless network interface status (whether it is up or down, or if it is connected to any network), such as iw, iwlist, ip, ifconfig and others.

 

And some are used to connect to a wireless network, and these include: nmcli, is a command-line tool used to create, show, edit, delete, enable, and disable network connections, as well as control and display network device status.

 

First, start by checking the name of your network device using the following command. From the output of this command, the device name/interface is wlp1s0 as shown.

$ iw dev

phy#0
	Interface wlp1s0
		ifindex 3
		wdev 0x1
		addr 38:b1:db:7c:78:c7
		type managed

 

Next, check the Wi-Fi device connection status using the following command.

iw wlp2s0 link

Not connected.

 

From the output above the device is not connected to any network, run the following command to scan available Wi-Fi networks.

sudo iw wlp2s0 scan
       
command failed: Network is down (-100)

 

Considering the output of the above command, the network device/interface is DOWN, you can turn it On (UP) with the ip command as shown.

$ sudo ip link set wlp1s0 up

 

If you get the following error, that means your Wifi is hard blocked on Laptop or Computer.

RTNETLINK answers: Operation not possible due to RF-kill

 

To remove or unblock you need to run the following command to solve the error.

$ echo "blacklist hp_wmi" | sudo tee /etc/modprobe.d/hp.conf
$ sudo rfkill unblock all

 

Then try to turn ON the network device once more, and it should work this time around.

$ sudo ip link set wlp1s0 up

 

If you know the ESSID of the Wi-Fi network you wish to connect to, move to the next step, otherwise issue the command below to scan available Wi-Fi networks again.

$ sudo iw wlp1s0 scan

 

And lastly, connect to the wi-fi network using following command, where Hackernet (Wi-Fi network SSID) and localhost22 (password/pre-shared key).

$ nmcli dev wifi connect Hackernet password localhost22

 

Once connected, verify your connectivity by doing a ping to an external machine and analyze the output of the ping as shown.

$ ping 8.8.8.8

PING 8.8.8.8 (8.8.8.8) 56(84) bytes of data.
64 bytes from 8.8.8.8: icmp_seq=1 ttl=48 time=61.7 ms
64 bytes from 8.8.8.8: icmp_seq=2 ttl=48 time=61.5 ms
64 bytes from 8.8.8.8: icmp_seq=3 ttl=48 time=61.6 ms
64 bytes from 8.8.8.8: icmp_seq=4 ttl=48 time=61.3 ms
64 bytes from 8.8.8.8: icmp_seq=5 ttl=48 time=63.9 ms
^C
--- 8.8.8.8 ping statistics ---
5 packets transmitted, 5 received, 0% packet loss, time 4006ms
rtt min/avg/max/mdev = 61.338/62.047/63.928/0.950 ms

 

Was this answer helpful? 0 Users Found This Useful (0 Votes)