With dd command you can copy an entire hard drive or just a Linux partition. Let's start with cloning one of our partitions. In my case, I have the following drives: /dev/sdb, /dev/sdc. I will clone /dev/sdb1/ to /dev/sdc1.

 

First list these partitions using the fdisk command as shown.

# fdisk -l /dev/sdb1/ /dev/sdc1

 

Now clone a partition /dev/sdb1/ to /dev/sdc1 using the following dd command.

# dd if=/dev/sdb1  of=/dev/sdc1 

 

The above command tells dd to use /dev/sdb1 as input file and write it to output file /dev/sdc1.

 

After cloning Linux partition, you can then check both partitions with:

# fdisk -l /dev/sdb1 /dev/sdc1

 

How to Clone Linux Hard Drive

 

Cloning a Linux hard drive is similar to cloning a partition. However, instead of specifying the partition, you just use the entire drive. Note that in this case it is recommended that the hard drive is same in size (or bigger) than the source drive.

# dd if=/dev/sdb of=/dev/sdc

 

This should have copied the drive /dev/sdb with its partitions on the target hard drive /dev/sdc. You can verify the changes by listing both drives with fdisk command.

# fdisk -l /dev/sdb /dev/sdc

 

How to Backup MBR in Linux

 

dd command can also be used to backup your MBR, which is located at the first sector of the device, before the first partition. So if you want to create backup of your MBR, simply run:

# dd if=/dev/sda of=/backup/mbr.img bs=512 count=1. 

 

The above command tells dd to copy /dev/sda to /backup/mbr.img with step of 512 bytes and the count option tells to copy only 1 block. In other words you tell dd to copy the first 512 bytes from /dev/sda to the file you have provided.

Was dit antwoord nuttig? 0 gebruikers vonden dit artikel nuttig (0 Stemmen)